I hope all of you had awonderful Thanksgivings, filled with friends, family, love and laughter. Today, we’re decorating every square inch of our house for Christmas, and starting our biggest DIY project yet…homemade bunk beds for the kids!
Today I’m sharing a how-to for a clock made from an old picture frame that I thought many of you would enjoy. It’s a great project to squeeze in before the craziness of Christmas hits, or even to give as a gift to someone that appreciates handmade treasures as much as you do.
The detailed tutorial is below!
Nikki, In Stitches
- Picture frame
- Fabric (Your piece needs to be large enough to cover the insert of the frame, with a few inches extra all around. I used linen for my clock, but depending on the size of your frame, you might want to check your scrap bin!)
- Ruler, pencil, and scissors
- Silhouette Cutting System
- Stencil Vinyl for fabric and Fabric Ink
- Sponge for applying ink (I actually use a Q-tip most of the time!)
- Batting (Again, a piece large enough to cover the frame insert, plus a little extra!)
- Cardboard (Just a side of an old box will probably do!)
- Spray adhesive
- Cordless drill and drill bit. (For the clockworks that I purchased, I needed a 1/2″ drill bit.)
- Clockworks (You can find a basic clock insert at your local craft store…that’s all that I used. I did however, but an extra set of hands that were longer than what came with the actual clock mechanism. If your frame is smaller, you don’t need to worry about this!)
- Design your clock face in the Silhouette Studio® Design software.
You can use my design below as a guide for size and placement. There are a few things to note:
*The swirls at the corners are are the same “flourish” I used on my “Give Thanks” board.
*The font for the numbers is Academy Engraved LET.
*Be sure your design extends a bit larger than you frame so you don’t risk seeing where it cuts off.
*You will need to cut this in sections since the cutting mat is only 12″ wide. (I cut the numbers as one, and each corner separate.)
- Ink design on fabric. (I very lightly traced the shape of my frame insert onto the linen, and also marked the center of each side before inking. This way, I could be sure my design extended all the way to the edge, and use the center marks as registration marks, to make sure my designs were centered and symmetrical.)
- Let ink dry and remove vinyl stencils.
- Cut a piece of cardboard the exact size of your frame insert. Drill a hole in the center where the clockworks will go through from the back to the front.
- Drill a hole in the center of the frame insert as well.
- Using spray adhesive, adhere a layer of batting to the cardboard. Then adhere your inked clock face to the batting. Wrap excess batting and fabric around to the back. (I just used another little spray of adhesive to keep the layers of in place back there!)
- With scissors, clip a hole in the center of your batting and fabric to allow the clockworks to come through. (Note: This should be right on top of the hole you drilled in the cardboard!)
- Place cardboard in frame.
- Place frame insert into frame.
- Insert clockworks following the manufacturers instructions.